Lease for as low as $/week
The ATP front mount intercooler system for the Mazdaspeed3 features a Garrett GT high density bar and plate intercooler core, capable of supporting up to 400 horsepower while effectively reducing intake air temperatures by over 30 degrees. This intercooler kit will allow the MS3 to operate at full power without holding back due to intercooler heat soak. Power gains are huge on a stock or upgraded turbo utilizing this intercooler system, ATP has observed an incredible performance difference of +38hp and +46 ft/lbs of torque over stock with this intercooler and a short ram intake alone! By lowering the peak operating temperature, the chance of engine knock is also significantly reduced under heavy acceleration and aggressive driving.
Need more power? A larger 600hp capable intercooler core is also available. The Garrett 600hp core may require some trimming or cutting of the stock bumper support to install. Select the intercooler core size that best suits your application below.
The ATP FMIC is a direct bolt on for the Mazdaspeed3 and does not require any bumper cutting to install. Multi-layer silicone couplers, T-bolt clamps, hardware and complete installation instructions are included for a true bolt-on front mount intercooler solution for your MS3. The hotside turbo pipe is pre-flanged for an HKS compatible blow off valve, but can be swapped upon request. The ATP front mount intercooler kit is available with blue, black or red silicone couplers.
Note:The intercooler kit is available with an HKS or Greddy blow off valve flange. Please indicate which blow off valve you have in the note section when you order.
Standard Garrett 400HP intercooler or Garrett 600HP intercooler